Using Your Digital Audio Baby Monitor 13
ENGLISH
3. Using Your Digital Audio Baby Monitor
Please read these instructions carefully, and be aware that this Digital Audio
Baby Monitor is only intended as an aid. It is not a substitute for responsible and
proper adult supervision.
3.1 Power on or off
3.1.1 Power on or off the baby unit
• Press and hold to power on the baby unit. The Power/Link indicator turns
on.
• Press and hold again to power off the baby unit. The Power/Link indicator
turns off.
3.1.2 Power on or off the parent unit
• Press and hold to power on the parent unit. The LCD screen turns on.
• Press and hold again to power off the parent unit. The LCD screen turns
off.
NOTE
If you place the parent and baby units too close together, you may hear a high
pitched noise. This is not a fault. The units are designed to be operated at some
distance apart, e.g. in separate rooms, so move the units further apart.
If the Power/Link indicator flashes on the baby unit or parent unit, they are not
linked to each other. Make sure that both units are powered on, and reduce the
distance between the units, but not closer than 1 metre.
3.2 Speaker volume
3.2.1 Adjust speaker volume of the baby unit
You can adjust the speaker volume of the baby unit from
Volume 1
to
Volume 5
.
• Press or on the baby unit.
3.2.2 Adjust speaker volume of the parent unit
You can adjust the speaker volume of the parent unit from
Volume 1
to
Volume 3
, or
turn it off.
To Next Page
Loading...
Need help?
General
