Motorola MBP853CONNECT - Initial Setup and Getting Started; Connecting the Baby Unit to Power; Installing Parent Unit Battery and Power

Getting Started 11
ENGLISH
2. Getting Started
2.1 Baby Unit Power Supply
1. Connect the small plug of the power adapter to the Baby Unit (camera) and
the other end to a suitable mains power socket.
NOTE
Only use the enclosed power adapter (5V DC / 1500mA).
2. Slide the ON/OFF switch to the ON position. The power LED will light up
in blue.
3. Slide the ON/OFF switch to the OFF position to turn the Baby Unit off.
2.2 Parent Unit Battery Installation
1. Insert the wire tab of the rechargeable battery pack into the contact slot as
shown above and fit the battery pack into the compartment.
ON OFF
Switch to turn ON
the camera
Power adapter plug
Black
Red
Small cross head or
Flat end screw driver