Motorola MC9090 - The scanner does not beep or make any audible confirmations; The scanner powers itself off; The scanner is not reading RFID tags

The scanner does not beep or make any audible
confirmations
Possible Cause 1
The volume is turned down.
Solution
Increase the volume.
The scanner powers itself off
Possible Cause 1
The battery is low or dead.
Solution
Recharge the battery.
Possible Cause 2
A period of inactivity is reached.
Solution
The length of inactivity before shutdown can be altered in the operating system:
Start > Settings > System tab > Power > Advanced.
The scanner is not reading RFID tags
Possible Cause 1
The RFID Read application is not installed.
Solution
Contact WinWare support.
Page 4 of 6
© 2010 WinWare, Inc. All ri
g
hts reserved. CS–CM-001-01052010