Completing Retrofit
Procedure
1. At bottom of radio body, plug accessory plug into accessory
connector.
2. At front of control head, plug in modular connector on
microphone cord.
3. Refer to Figure 1 and at control head trunnion connect S-hook on
microphone cable to trunnion.
4. If radio body has not been relocated in vehicle, skip remaining
steps of this procedure. Otherwise, continue with step 5.
5. Extend and reroute antenna cable as required to reach new
location of radio body.
6. At rear of the radio body, connect power cable and antenna cable.
7. In vehicle engine compartment, connect remote mount power
cable to vehicle battery circuit.
To Previous Page
Loading...
