Overview
Maintenance 3-1
1.0 Overview
This chapter explains, step by step, how to disassemble and assemble the radio, to transceiver
board level. The chapter also contains a list of test equipment required to service the radio and the
procedure for radio alignment/test setup is also available in this chapter.
Note:
Control head type may differ from the diagram shown in this section, depending on the
models supported. However, the instructions pertaining to its removal and assembly are
the same across models.
2.0 Disassemble the Radio
2.1 Remove the Control Head
Figure 3-1
Control Head Removal.
1.
Insert a small flat blade screw driver, or similar, in the recess between the control head and the
transceiver (to minimise cosmetic damage to the radio cover start from the bottom side).
2.
Press until the side of the control head releases and then repeat the operation on the opposite
side of the radio.
3.
Pull the control head away from the transceiver.
4.
Remove the flex from the socket on the control head board.
Recess
www.myradio168.net
To Next Page
Loading...
