Disassemble the Radio
3-2 Maintenance
2.2 Remove the Top Cover
Figure 3-2
Top Cover Removal.
1.
Insert a small flat blade screw driver in the side recess of the radio chassis.
2.
Lift the top cover over the chassis.
2.3 Remove the Transceiver Board
Figure 3-3
Transceiver Board Removal.
1.
Remove the power and antenna connector retaining clips by inserting a small flat blade screw
driver between the clip and the top of the chassis wall and gently prying the clip upwards.
2.
Remove 13 screws from the transceiver board using a T8 TORX driver.
Recess
Chassis
Recess
Top Cover
Flex
Transceiver Board
Clip
Clip
Recess
Protruding Tabs
www.myradio168.net
To Next Page
Loading...
