54 MTM5400 Mobile Terminal Installation Manual INSTALLATION
Figure 24 Connectors on the Junction Box - Rear Panel
Connection Plan for the Junction Box Accessory Terminal
Connection Plan for the Speaker
4 = Connector for programming cable
FLN 9636
This is a legacy connector which
currently is not supported. For
programming the transciever, use
PMKN4105A programming cable that is
connected directly to the transciever.
5 = Connector for accessory connector
kit PMKN4026
6 = Connector for adapting a laptop via
RS232 cable
7 = TELCO-connector for fist
microphone (GMMN4063)
To Next Page
Loading...
