PROGRAMMING THE RADIO MTM700 Mobile Terminal / Basic Service Manual 4 - 5
Hereafter, there is no need for quick sequence of pressing the radio keys.
8. Press the “Down” navigation key to scoll to “Cell Lists”
9. Press the “Ok” key.
10. Scroll through the lists, select List1 and press the “Ok” key to view the frequencies.
Restore the Frequencies of the Radio from a File
To restore previously saved frequencies of the radio, perform the following steps:
1. After testing your radio on the IFR, connect the setup shown in Figure 1 or Figure 2.
2. Run the CPS software on your PC.
3. In the menu bar click “Tools”, “Copy Wizard”.
• Click on “Read from file”.
• Click on “Browse”.
• Open (Your selected File name) file.
• Click on “Next”.
• Click on “Select All”.
• Click on “Next”.
• Click on “Write”.
• Click on “Done”.
Note: Click on toolbar “Read Phone” to check whether the correct frequencies were
entered into the radio.
Application Programming
Note: Login as “Administrator” to perform this task.
1. On the menu bar click “Tools”, “Write Software”.
Note: The CPS reads data from the radio. A progress bar is displayed on the computer
screen showing the reading status. After a successful reading, the “Write Software
To Phone” window appears on the computer screen.
2. Press the “Write” button.
Note: The application is now being written into the radio. A progress bar is displayed on
the computer screen showing the writing status. After a successful writing, the
message “The Operation Was Successful” appears on the computer screen.
3. Press the “OK” button.
4. Click the Toolbar “ R” (Reset) icon to put radio into normal operating mode.
To Next Page
Loading...
