50
English
RADIO CALLS
(TRUNKED
OPERATION ONLY)
left. When the last digit on the display has been
erased, additional presses of this key or the
/ key will cause you to leave the edit mode
without making any changes.
When the maximum number of digits for the
radio ID is reached, the cursor will disappear. If
you try to add any more digits, you will hear an
invalid (bad) keypress alert tone.
TRUNKED TELEPHONE OPERATION
The trunked telephone feature allows you to
receive calls using your trunked radio. When
you are dialing from the keypad, your radio
may be programmed with either buffered dial
(you enter all digits and press the PTT button
before the digits are sent out) or live dial (each
digitissentoutasitispressed).
Receiving a Telephone Call
Note: The call received status annunciator, F,
flashes when you receive a call, but is
not displayed when you answer the
call.
Sending a Telephone Call
There are three steps in sending a phone call:
1. Accessing the Telephone System
1 When a telephone call is
received, you will hear a
ringing tone.
Alternates between:
and
PLANT POLICE
PHONE CALL
2 Press the pre-pro-
grammed Phone button
or call response button
to answer the call.
3 Begin your conversation. Press the PTT but-
ton to talk; release the PTT button to listen.
4 When you have finished your conversation,
press . or the phone button to hang up.
5 The radio will return to
thehomedisplay.
1
/ until PHON is
displayed.
2 l (the softkey below PHON).
PHONE CALL
PLANT POLICE
MSG SCAN PHON
To Next Page
Loading...
