32
English
GETTING STARTED
Attaching the Side Connector Cover
r
TURNING RADIO ON OR OFF
Turn the radio on by rotating the volume
control clockwise. The radio goes through a
power-up self check and, if it passes the
check, the display momentarily shows SELF
TEST. A good-power-up, high-pitched tone
sounds to indicate that the radio has passed
the self check.
If the radio fails the self check, the display
shows ERROR XX/XX (where XX/XX is an
alphanumeric error code), accompanied by a
bad-power-up, low-pitched tone. Turn the
radio off, check the battery, and turn the radio
back on. If the radio still does not pass the self
check, a problem exists in the radio. Contact
your authorized Motorola dealer.
1 Place the loop (attached to the side con-
nector cover) over the antenna; then slide it
downward until it touches the top of the
radio.
2 Insert the tab on the top of the cover into
the slot above the connector.
3 Position the cover over the connector and
align the thumbscrew with the threaded
hole in the radio.
4 Tighten the thumbscrew to hold the cover in
place. Do not overtighten the thumbscrew.
Loop
Slot
Thumbscrew
Antenna
ON OFF
To Next Page
Loading...
