37
English
GETTING STARTED
VARIABLE RF POWER LEVEL
Radios can have more than one power level.
High power can be programmed on modes
where high power is permitted, and low power
canbeprogrammedonallothermodes.The
high-/low-power feature can be selected via
the radio feature menu.
SMART PTT (CONVENTIONAL
OPERATION ONLY)
This feature is programmable by your
authorized Motorola dealer.
Smart PTT is a per-mode feature which gives
the system manager better control of radio
operators. When smart PTT is enabled in your
radio, you cannot transmit on an active mode.
Three radio-wide variations of smart PTT are
available.
• Transmit Inhibit on Busy Mode—you are
prevented from transmitting if any activity is
detected on the mode.
• Transmit Inhibit on Busy Mode with
Wrong Squelch Code—you are pre-
vented from transmitting on an active mode
with a squelch code other than your own. If
the PL code is the same as yours, you are
allowedtotransmit.
• Quick-Key Override—This feature can
work in conjunction with either of the two
above variations. This feature allows you to
override the transmit-inhibit state by quick-
keying (two PTT button presses within a
3 The current talkaround
state appears on the
display for a few
seconds.
or
4 Then, the display
prompts for the new
state.
5 l below the desired talkaround state:
repeat (
RPTR)ordirect(DIR).
6 The radio returns to the
home display.
REPEATER MODE
DIRECT MODE
DIR RPTR
DIR RPTR
To Next Page
Loading...
