MW810 Display Owner’s Manual 13
6802982C85-C
Display Indicators
The display has two LED indicators that are located at the front panel (Display Mode and
Display Temperature) and Emergency LED at the top.
These LED's alongside with display illumination provide the following indication about
operational conditions.
STATE DISPLAY
MODE LED
TEMP
LED
EMERG
LED
KEY
ILLUM
LABELS
ILLUM
BACK
LIGHT
Power off OFF OFF OFF OFF OFF OFF
Video on (normal operational mode) Green OFF ON ON ON ON
Video on (low temperature, heater
on)
Green Yellow ON ON ON ON
Video on (high temperature) Green Red ON ON ON ON
Video off Yellow ON ON ON OFF
No video cable* Yellow ON ON ON ON
System standby mode Yellow (50%
intensity)
OFF ON (50%
intensity)
OFF OFF OFF
Low car battery voltage Yellow ON ON ON ON
NOTE: When there is no video cable connected to the display, No Cable message will pop
up on the screen for 3 seconds and then disappear.
To Next Page
Loading...
