11
English
During Calibration/Reconditioning, the battery is fully discharged
before being fully charged. As a result, the radio may shut down during
the discharge phase.
Charger Overview
Figure 1: Charger Overview
Table 6: Charger Overview and Description
Number Description
1–6 Charging Pockets – To charge batteries attached to a radio or stand-alone.
7 Display – For Pocket 1 only. Displays the available menu selections.
8 Keypad – For menu selection.
9 LED Status Indicator – Indicates the charging status of the battery.
10
Communications Interface – Supports charger reprogramming and data
upload to an IMPRES Battery Fleet Management System and iTM
communication through USB port. Refer to Table 2 for the selected Multi-Unit
Charger pockets that support iTM Communication.
11 Power Connector Inlet – Compatible with Power Supply in Table 3.
1
7
8
11
10
23 456
9
123 456
7
8
9
MN003555A01.book Page 11 Wednesday, February 14, 2018 2:40 PM
To Next Page
Loading...
