Mobile Antenna Installation 9
Mini-UHF Connector Installation #28-84606M01
Installation Instructions
Use Motorola tool part # 66-80388A26 (Refer to Figure 8).
1. Slip ferrule and collar onto cable. See Figure 10.
2. Prepare cable to strip dimensions as per Figure 11.
3. Insert stripped cable into plug body until conductor is exposed (front end) and dielectric
bottoms inside body. See Figure 10.
4. Crimp center contact using crimp area C of Figure 8 . Crimp at base of center contact, avoid
crimping at the tip. Refer to Figure 9.
5. Push collar forward onto plug assembly. Fit cable braid over support sleeve of connector. See
Figure 10.
6. Push ferrule over braid until flange butts against connector body. Refer to Figure 10. Using
the correct crimp area of tool, crimp ferrule close to plug body. Crimp ferrule for a second time
close to cable end.
7. Protuding center conductor should be trimmed with end of center contact.
Figure 8. Motorola Crimping Tool 66-80388A26
.256
.319
.068
.051
.213
A
B
C
D
E
FIVE CRIMP AREAS
To Next Page
Loading...
