13 - 4 Symbol LS2208 Product Reference Guide
Prefix/Suffix Values
You can append a prefix and/or suffix to scan data for use in data editing.
To set a value for a prefix or suffix:
1. Change the scan data format by scanning the appropriate Scan Data Transmission Format on page 13-4.
2. Scan the appropriate prefix/suffix bar code below.
3. Scan a four-digit number (i.e., four bar codes from Appendix D, Numeric Bar Codes) that corresponds to that
value.
4. To correct an error or change a selection, scan Cancel on page D-3.
Scan Prefix
Scan Suffix
Scan Data Transmission Format
To change the scan data format, scan Scan Options and one of the following four bar codes corresponding to the
desired format:
• Data As Is
• <DATA> <SUFFIX>
• <PREFIX> <DATA> <SUFFIX>.
Scan Enter on page 13-5 to complete the change. To set values for the prefix and/or suffix, see Prefix/Suffix
Values on page 13-4. Scan Data Format Cancel on page 13-5 to cancel the change.
If you require a carriage return/enter after each scanned bar code, scan the following bar codes in order:
1. Scan Options
2. <DATA> <SUFFIX>
3. Enter (on page 13-5).
Scan Options
To Next Page
Loading...
