Motorola V60 - Installing special battery insert

To Next Page

To Previous Page

Notes:

• Your phone plays a confirmation beep when docked. Wait for this beep before undocking.

• While in Vehicular Mode, the phone operates on the vehicle’s integrated cellular antenna.

Mercedes-Benz recommends keeping the phone docked in the cradle while operating the vehicle. If you

must use the handset for privacy operation, stop the vehicle prior to removing the phone from the cradle.

Installing the Special Battery Insert

The V60 cradle is supplied with a special insert to make it easier to align the phone with the cradle’s embedded connector

when you use certain batteries.

The slim battery is supplied as a standard component in the CDMA V60 kit, while the high performance battery is standard

in the TDMA V60 kit. You should remove the insert when using the optional extra capacity battery.

To install the insert:

Pivot the cradle down to securely latch it.

The cradle should never be placed into the holder with the phone’s flip open.

in order to prevent damage to the phone when the console cover is closed.

Step

Align the four tabs on the side of the insert with the corresponding slots in the cradle.

Gently push the insert into the slots until it snaps into place.

If you are using the slim battery, the side marked “FOR USE WITH SLIM BATTERY” should face up.

If you are using the high performance battery, the side marked “FOR USE WITH HIGH PERFORMANCE BATTERY” should face up.

If you plan to use the extra capacity battery with your phone, remove the insert by gently prying it out with a small

flat screwdriver, exercising care not to mar the side walls of the cradle.

Step

Other manuals for Motorola V60