36 VC70 Vehicle Computer
8. Secure the power cables on both sides of the power supply with
cable ties as close as possible to the connectors.
Ignition Sensing
The vehicle computer contains an Ignition Sense feature that detects
when the ignition switch or key switch is turned off and shuts the vehicle
computer down after a pre-programmed time-out. This feature allows the
operator to use the vehicle computer for a predetermined time period
after the ignition switch or key switch is turned off, then shuts the vehicle
computer down automatically to prevent over-discharge of the forklift
battery. The time-out period is adjustable by the user. The normal current
draw of a suspended vehicle computer is approximately 500mA. When
the vehicle computer shuts down using the Ignition Sense feature,
current draw is reduced to approximately 5 mA. This feature provides the
automatic shutoff functionality of an external relay, without requiring an
actual relay and has the added benefit of allowing the user to work for a
preset time period before shutting down.
The power cable must be connected to the ignition switch or key switch.
See Forklifts and Trucks with 12V, 24V, 36V and 48V Batteries on page
33 for information on connecting the power cable to enable the Ignition
Sense feature.
1. Tap > Settings > Control Panel > System Manager icon. The
System Manager window displays.
2. Select the Miscellaneous tab.
The VC70 display can be blanked when the vehicle is moving
to eliminate driver distraction for safety considerations.
To recover from display lock:
1. Press and hold on touch screen (more than 1 second).
2. Remove your finger from the screen to resume operation.
NOTE These settings are not persistent across a cold boot.
To Next Page
Loading...
Need help?
General
