Motorola XPR 6550 User Manual

20
General Radio Operation
Universal Connector Cover
The universal connector cover is located on the antenna side of the
radio. It is used to connect certain accessories to the radio.
Note: To prevent damage to the connector, shield it with the
connector cover when not in use.
Remove the Connector Cover
Attach the Connector Cover
1 Insert a flat-bladed
screwdriver into the area
between the bottom of the
cover and the slot below the
connector.
2 Hold the top of the cover with
your thumb while you pry the
bottom of the cover away
from the radio with the
screwdriver.
1 Insert the hooked end of the
cover into the top of the
connector. Press downward
on the cover’s top to seat it
into the slot.
2 Press the cover’s lower tab
below the connector until it
snaps in place.





 

 
Tab

Motorola XPR 6550 Specifications

General

Channels	128
IP Rating	IP57
Keypad	Yes
Emergency Button	Yes
Operating Temperature	-30°C to +60°C
GPS	Optional
Bluetooth	No
Frequency Range	VHF: 136-174 MHz, UHF: 403-470 MHz
Power Output	VHF: 1-5W, UHF: 1-4W
Battery Life	9 hours (analog mode)
Digital Protocol	DMR