22
GETTING STARTED
HANDS-FREE USE/VOX
Motorola Solutions XT Series radios can
operate hands-free (VOX) when used with
compatible VOX accessories.
With Compatible VOX Accessories
The default factory setting for VOX sensitivity
level is OFF (Level 0). Before using VOX, use
the Computer Programming Software (CPS) to
change the VOX sensitivity level from
1 (lowest) to 9 (highest).Then, perform the
following steps:
1. Turn the radio OFF.
2. Open accessory cover.
3. Insert the audio accessory’s plug firmly into
accessory port.
4. Turn radio ON. The LED Indicator will be solid
red for 2 seconds.
5. Lower radio volume BEFORE placing
accessory near ear.
6. To transmit, speak into accessory microphone
and to receive, stop talking.
Note: To order accessories, contact your Motorola
Solutions point of purchase.
Hands Free without Accessories (iVOX)
• Enable / Disable iVOX via CPS.
• There is a short delay between the time when you
start talking and when the radio transmits.
Setting VOX Sensitivity
The sensitivity of the radio's accessory or
microphone can be adjusted during VOX
operation to suit different operating
VOX
Accessory
Accessory Port/
Connector
To Next Page
Loading...
