Programming Mode
20
k
k
Channel
(XU2600 and XV2600 Only)
Interference Eliminator Code
The Interference Eliminator Code helps minimize interference by providing you with
a choice of code combinations, which filter out static, noise, and unwanted
messages.
Make sure k is accessed. Please refer to page 11.
Note: To hear everyone on your frequency, select Interference Eliminator Code 0.
• Make sure k is accessed. Please refer to page 10.
• The Channel number flashes. l and Code will display
alternately.
• Press [ or ] until the desired Channel is selected.
Frequency
• Press \ once, l indicator illuminates and the
Frequency flashes.
• Press
[
or
]
to choose desired Frequency.
• Exit the Programming Mode by holding down M.
• To set the Code, press \ until the Code number display begins
to flash.
• Then press
[
or
]
to choose the Code.
6
6881038B80.book Page 20 Wednesday, September 26, 2001 4:16 PM
To Next Page
Loading...
