CSD Series Variable Frequency AC Drive
MOTORTRONICS
- 69 -
Table 9 E
9.5 Drive Settings - The following chart may be used to record the changes
made to the factory settings.
Fn XX Function Page Set To Check Revised Check
00 Capacity 29
01 -02 Accel / Decel Time 29
03
Remote Operation Select /
Rev. Lockout / Initial Frequency
30
04 Parameter Lock Select 31
05 V/f Pattern 31
06 - 07 Freq. Limit 32
08 - 09 Speed Agreed Detection 32
10 Control Mode Select 32
11 Frequency Command Method Select 32
12 - 15 Stall Prevention 33
16 Drive Start and Reset 34
17 -24 Multispeed & Timer Control 35
25 Master Frequency 36
26 - 29 Analog Input Frequency Command 36
30 Power Voltage 37
31 - 32 Momentary Power Loss 37
33 Analog Input Signal Scan Times 37
34 - 35 Auto Restart 37
36 Motor Poles 37
37 - 41 V/f Pattern 38
42 Start Frequency 38
43 Carrier Frequency 38
44
Stopping Mode and Braking Resistor
Protection
39
45 -46
Multifunction Analog Output Selection
(terminals 15 and 16)
39
47 Display Mode 39
48
Dynamic Braking and Priority of Stopping
and Speed Search and AVR Control
39
49 -50 Accel / Decel Time 2 40
51 -52 Display Mode 40
53 - 55 DC Braking 41
56 - 58 Multifunction Input 41
59 - 60 Reserved 44
61 Multifunction Output 44
62 - 64 Reserved 45
65 - 68 Prohibit Frequency Control 45
69 Electronic Thermal Protection 46
70 -71
Electronic Thermal Overload Reference
Current
47
72 Torque Boost 47
73 -74 Reserved 47
75 -76 Slip Comp. 47
77 -79 Overtorque Control 48
80 -81 S Curve 48
82 -83 Energy Savings 49
84 -91 Sequence Control 49
92 -94 Vibration Control 50
95 -96 Reserved 50
97 -98 Fault Control (F.C.) Control 50
99 Reserved 51
100 - 102 Comm. Parameter Control 51
103 -122 Reserved 51
123 Factory Setting 52
124 CPU Version 52
125 Fault Sequence Reference 52
To Next Page
Loading...
Need help?
General
