Mount-It! 2781 User Manual

English
Installation Instruction
1
UNPACKING INSTRUCTIONS
! Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
! Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
! Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
! Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
! Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

Mount-It! 2781 Specifications

General

VESA Compatibility	75x75mm, 100x100mm
Material	Steel, Aluminum
Number of Screens Supported	1
Height Adjustable	Yes
Color	Black
Category	Racks & Stands
Placement	Desk
Maximum Screen Size Supported	32 inches
Rotation	360 degrees
Number of Shelves	0

Summary

Install the Pole to the Desktop

Weighted Base Install

Install the Pole(a) to the Weighted Base(b) using M5x14 Bolts(e) and the Allen Key(o).

Existing Grommet Base Install

Install the Grommet Base Plate(m) to the Pole(a) using M5x14 Bolts(e) and the Allen Key(o).

Self Drilled Grommet Base Install

Install the Grommet Base Plate(m) to the Pole(a) using M5x14 Bolts(e) and the Allen Key(o).

Install Arm to the Pole

Attach Swivel Arm and Wire Clips

Install the Swivel Arm(c) to the Pole(a) and attach Wire Clips(n1, n2).

Attach the VESA Plate to the Monitor

VESA Plate for Flat Back Monitors

Attach the VESA plate using M4x12 Bolts(q) for monitors with a flat back.

VESA Plate for Curved or Recessed Back Monitors

Attach the VESA plate using M4x30 Bolts(r) and M4 Spacers(s) for curved or recessed backs.

Monitor Adjustments and Wire Management

Fix Tilt Angle and Adjust Monitor Level

Tighten the bolt with Allen Key(o) to fix tilt angle or adjust monitor height.

Manage Wires and Store Allen Keys

Use Allen Key(o) for adjustments and store keys in Wire Clip(n1).