EN - 8
4.5 KEY IGNITION SWITCH (Fig. 4.1 no.5)
«ON» activates all parts;
– On being released at the «START» position,
4.6 THROTTLE LEVER (Fig. 4.1 no.6).
«CHOKE» ((if provided) cold start
– The «CHOKE» position (if provided) enriches
«FAST».
– When cutting, shift into «FAST”.
4.7 REVERSE GEAR CUTTING CONSENT
PEDAL (Fig. 4.1 no. 7)
-
to stop.
Mechanical transmission
4.11 CLUTCH / BRAKE PEDAL
(Fig. 4.2 no.11)
part of its travel it acts as a clutch, engaging
IMPORTANT Do not keep the pedal half
way between clutch engagement or disen-
gagement, as this can cause overheating and
damage the transmission belt.
NOTE When the machine is in movement,
keep your foot off the pedal.
4.12 SPEED CHANGE LEVER
(Fig. 4.2 no.12)
This lever has six positions for the four for-
reverse «R».
WARNING! Reverse must be en-
gaged when the machine has stopped.
Hydrostatic transmission
4.21 BRAKE PEDAL (Fig. 4.3 no.21)
This pedal works the brake on the rear
wheels.
4.22 CLUTCH PEDAL (Fig. 4.3 no.22)
speed.
-
ing that increasing the pressure on the
WARNING! Reverse must be en-
gaged when the machine has stopped.
NOTE If the drive pedal is used, wheth-
er forwards or for reverse, when the parking
brake (4.2) is engaged, the engine stops.
4.23 HYDROSTATIC TRANSMISSION
DISENGAGEMENT LEVER
(Fig. 4.3 no.23)
«A
«B
IMPORTANT To avoid damaging the
transmission unit, this operation must be car-
To Next Page
Loading...
Need help?
General
