EN - 16
WARNING! Always replace damaged or
bent cutting means; never attempt to repair
them! ALWAYS USE ORIGINAL CUTTING
MEANS!
-
chine.
-
-
7. TROUBLESHOOTING
PROBLEM LIKELY CAUSE SOLUTION
– bad earthing to the engine or the
– earth connections of the
– starting conditions have not
– replace the fuse (10 A) (see 6.3.4)
leads
(see 5.2.a)
does not start
(see 5.3.3)
clean and have the correct gap
3. The engine stops
– earth connections of the
contact)
– fault in carburetion
fresh fuel
during cutting
to cutting height
raise the cutting height (see 4.4)
the cutting device is engaged
To Next Page
Loading...
Need help?
General
