EN - 15
6.2.1 Engine (Fig. 6.1)
-
6.2.2 Rear axle
its lubricant does not need changing or topping
up.
6.2.3 Battery (Fig. 6.2)
-
after purchase;
period;
-
-
possible.
IMPORTANT Recharging must be done us-
ing a battery charger at constant voltage. Other
recharging systems can irreversibly damage the
battery.
-
charging; this is connected to the corresponding
charger supplied (if included) or available on
IMPORTANT This connector must only be
used for connection to the maintenance battery-
charger indicated by the Manufacturer. For its
use:
– follow the instructions given in the relative in-
structions manual;
– follow the instructions in the battery manual.
6.3 INTERVENTIONS ON THE MACHINE
6.3.1 Aligning the cutting-means
assembly (Fig. 6.3)
-
-
6.3.2 Replacing the wheels (Fig. 6.4)
NOTE If you have to replace one or both rear
wheels, make sure that any differences in their
external diameter does not exceed 8-10 mm; on
the contrary, you must adjust the cutting-means
assembly alignment to prevent uneven mowing.
IMPORTANT Before remounting the wheel,
apply grease to the axle. Put the snap ring (1)
and shoulder washer (2) back in place.
6.3.3 Repairing or replacing tyres
-
6.3.4 Replacing a fuse (Fig. 6.5)
IMPORTANT A blown fuse must always be
replaced by one of the same type and ampere
rating, and never with one of another rating.
consult a Licensed Service Centre.
6.3.5 Removing, replacing and
reassembling of cutting means
WARNING! Always wear strong protec-
tive gloves to handle the cutting means.
To Next Page
Loading...
Need help?
General
