EN - 7
2.
3.
NOTE On the guard of the cutting means
(g. 1.D) there is the following symbol:
Indicates the rotation direction
4.3.3 Fitting the guard on the cutting
This guard must not be used
for other cutting devices.
1.
been used for other cutting devices.
2.
3.
4.
5.
the holes of the support.
6.
4.3.4
4.3.4.a Fitting cutting line head
1.
2.
3.
4.
to restore rotation.
5.
the couplers into the respective seats
IMPORTANT When using the cutting line
head, the additional guard (Fig. 7.E) must always
be tted, with line cutting knife (Fig. 25.A), .
4.3.4.b Removing cutting line head
1.
2.
4.3.4.c Fitting 3-point blade, saw
blade (if permitted)
Apply the guard to the blade.
1.
2.
3.
4.
5.
6.
4.3.4.d Removing 3-point blade,
saw blade (if permitted)
Apply the guard to the blade.
1.
To Next Page
Loading...
Need help?
General