EN - 11
d. Cutting around trees
6.4.1.b Adjusting the length of the
cutting line head during work
6.4.1.c 3-point blade
6.4.1.d Saw blade (if permitted)
When using the saw blade,
where permitted, the specic guard
must always be tted (cap. 4.3.3). The
blade must always be well sharpened
to reduce the risk of kickback.
When felling small trees, estimate the
direction in which the cut tree will fall, also
taking the wind direction into consideration.
Do not use the right-hand area of the
6.5 ADVICE ON OPERATION
• During use, the engine should be stopped
NOTE Avoid using the machine at full
power for the rst 6- 8 working hours.
IMPORTANT Stop the engine ( par.
6.5) when moving between work areas.
6.6 STOP
•
•
•
When you have reduced throttle
speed to a minimum, it will take a few
seconds for the cutting means to stop.
The engine may be very hot immediately
after it is shut down. Do not touch. The
engine can cause burn injuries.
6.7 AFTER OPERATION
• Clean all traces of dust and debris
•
IMPORTANT Stop the engine ( par. 6.5),
remove the spark plug cap (g. 12.H; g.
13.H) and apply the blade protection device
whenever you leave the machine unattended.
7. ROUTINE MAINTENANCE
7.1 GENERAL
IMPORTANT The safety regulations to
follow during machine use are described
in Chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
Before performing any
maintenance operations:
• Stop the machine;
•
come to a complete stop;
•
•
To Next Page
Loading...
Need help?
General