EN - 9
6.1.1 Using harnesses
to suit the operator’s height and build.
• Models with single belt
left shoulder to the right hip.
• Models with double belt
– the belts cross-over on the
6.2 SAFETY CHECKS
those outlined on the tables.
Always carry out the
safety checks before use.
6.2.1
Result
Suitable for the cutting
Connection point of
event of danger.
Sharp
Clean
Electric cables and
6.2.2 Machine operating test
Action Result
engine is running idle.
Push the throttle control
lever
.
Release the throttle
control lever
.
to the neutral position
return to running idle.
Press the throttle control
the throttle control
.
Press the engine
If any of the results fails to comply
with the following tables, do not use the
machine! Take it to a service centre to
be checked and repaired if necessary.
6.3 STARTUP
1.
2.
3.
not touch the ground or other objects.
6.3.1
A “cold” start of the engine means
starting it after at least 5 minutes from when
it was switched off or after refuelling.
IMPORTANT To prevent distortions, the
drive tube must not be used as a support
for the hand or knee during startup.
To Next Page
Loading...