EN - 10
IMPORTANT To avoid breaking the starter
cable, do not pull the whole length of it or
let it slide along the edge of the cable guide
hole. Release the starter grip gradually,
to prevent it ying back uncontrollably.
1.
2.
3.
4. only for models with throttle shutter:
5.
in order not to lose control of the
6.
7.
8. Pull the starter grip again until
9.
9.a only for models with throttle shutter:
9.b only for models without throttle
shutter: Use the throttle
10. Let the engine run idle for at least 1
IMPORTANT If the starter grip is pulled
repeatedly with the starter on, it may ood
the engine and make starting dicult. “
If the engine oods (see paragraph 7.6).
6.3.2 Warm start
in points 1 - 5 - 8 of the previous procedure.
6.4 OPERATION
NOTE Before tackling a mowing job for the rst
time, get to know the machine, learn the most
suitable cutting techniques, make sure your wear
the harnesses correctly, grip the machine rmly
and make the movements required by the job.
•
•
6.4.1
6.4.1.a Cutting line head
Use ONLY nylon lines. The use of
metal lines, plasticised metal lines and/
or lines that are not suitable for the head
can cause serious injuries and wounds.
Do not use the machine for sweeping,
tilting the cutting line head. The power
of the engine could throw objects
and small stones 15 metres or more,
causing damage or injury to people.
a.
For heavier cutting it can be useful to tilt the
Do not work in this way if there
is the possibility of causing objects
to be thrown, which could harm
people, animals or cause damage.
b.
touch the ground and the cutting line is at the
c.
To Next Page
Loading...