EN - 6
I.
J. Harness
1. Single belt
2. Double belt
K.
L.
4. ASSEMBLY
IMPORTANT The safety regulations to
follow during machine use are described
in Chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
Unpacking and completing the
assembly should be done on a at and stable
surface, with enough space for machine
handling and its packaging, always making
use of suitable equipment. Do not use the
machine until all the instructions in the
“ASSEMBLY” section have been carried out.
4.1 ASSEMBLY COMPONENTS
4.1.1
1.
2.
box, including these instructions.
3.
4.
5.
4.2 HANDLE ASSEMBLY
4.2.1
1.
holes on the drive tube.
2.
3.
4.2.2
1.
2. 4.C
sure that the controls are on the right.
3.
4.A
4.
NOTE By loosening the knob (g. 4.A), you can
turn the handlebar to reduce its size for storage.
4.3
MEANS AND SPECIFIC GUARDS
Wear protective gloves.
4.3.1 Choosing cutting means
Every cutting means must
be tted with a specic guard, as
indicated by the following directions
in the Technical Data table.
job to be done, according to these general indi-
• the cutting line head
• the 3-point blade is suitable
•
IMPORTANT When the cutting
means has to be changed, dismantle
all the elements of the device.
4.3.2 Fitting the guard on the
IMPORTANT Whenever you use this
protection, make sure that the plate of the
transmission tube (g. 5.B, g. 5.E) is assembled.
1.
To Next Page
Loading...
Need help?
General