–
b. Machine cutting width; wider settings involve high-
er energy consumption.
c. Operator behaviour that should be avoided:
–
frequently whilst working.
– Setting a cutting height that is too
low for the lawn conditions.
– Working at a speed that is too high in relation
to the amount of grass to be removed.
NOTE During use, the battery is protected against total
drainage with a protective device that switches o the ma-
chine and prevents its operation.
To optimise battery power reserve it is always recommend-
ed to:
– Cut the grass when the lawn is dry.
– Cut the grass frequently so that it doesn’t grow too tall.
– Set a higher cutting height when the grass is very
– Do not use the machine in "mulching"
mode with very high grass.
–
If the need arises to use the machine for sessions which ex-
– Purchase a second standard battery to immediately
compromising the continuity of operations.
– Purchase a battery with an extended power reserve
7.2.2 Battery removal and recharging
1. Open the battery compartment access hatch and re-
move the safety key.
2.
3.
4. Connect the battery charger to a power socket with the
voltage indicated on the rating plate.
5. Fully charge the battery according to the instructions in
the battery/battery charger booklet.
NOTE The battery is equipped with a protective device
that inhibits recharging if the environmental temperature is
not between 0 and +45 °C.
NOTE
7.2.3
When recharging is completed:
1. Remove the battery from the housing in the battery
charger (do not keep recharging when recharging is
completed).
2. Disconnect the battery charger from the mains power
supply.
3.
electrical contact.
Completely close the hatch again.
7.3 CLEANING
Clean thoroughly following the instructions below every
time it is used.
7.3.1 Cleaning the machine
• Always make sure the air intakes are free of debris.
• Do not spray water onto the motor and electrical compo-
• Do not use aggressive liquids to clean the chassis.
•
leaves residues or excessive grease.
•
7.3.2 Cleaning the cutting means assembly
Remove grass debris and mud accumulated inside the
chassis.
For side discharge: remove the discharge chute (if
7.3.3 Cleaning the grass catcher
7.4 NUTS AND BOLTS
-
ment is in a safe working condition.
7.5 CLEANING THE AIR FILTER
Proceed as follows:
1.
2.
3.
4.
the dust and residues.
5.
• Wear heavy duty gloves.
•
into account the weight and its division.
•
the machine and the characteristics of the vehicle or the
place where it must be placed or collected.
8. OCCASIONAL MAINTENANCE
Before commencing any inspections, cleaning or
maintenance/adjustments on the machine:
• Stop the machine.
•
within the reach of children or unauthorised persons).
• Make sure that all moving parts have come to a complete
stop.
• Allow the motor to cool before storing in an enclosed
space.
• Read the relevant instructions.
•
8.1 CUTTING MEANS
An improperly sharpened cutting means pulls at the grass
and causes the lawn to turn yellow.
To Next Page
Loading...
