Do not touch the cutting means until the key has
been removed and the cutting means is completely sta-
tionary.
All operations on the cutting means (disassembly,
sharpening, balancing, repairing, reassembly and/or
replacing) are complex jobs that require special skills as
well as special tools; For safety reasons, these jobs are
best carried out at a Authorised Service Centre.
Make sure damaged, misshapen or worn cutting
means are replaced, together with the securing screws,
to preserve balance.
IMPORTANT Always use original cutting means bearing
the code indicated in the 'Technical Data" table.
"Technical Data" table may be replaced in time with others
having similar interchangeable and operating safety fea-
tures.
9. STORAGE
9.1 STORING THE MACHINE
When the machine is to be stored away:
1. Wait for the engine to cool.
2. Remove the safety key.
3.
4. Check the integrity of the machine.
5. Store the machine:
• In a dry place.
• Protected from inclement weather.
• In a place where children cannot get to it.
• Making sure that keys or tools used for maintenance are
removed.
9.2 STORING THE BATTERY
humidity.
NOTE In case of prolonged periods of inactivity, recharge
the battery every two months.
10. HANDLING AND TRANSPORTATION
or tilted you must:
•
complete halt.
• Wear heavy duty gloves.
•
into account the weight and its division.
•
machine and the characteristics of the vehicle or the place
where it must be placed or collected.
• Make sure that machine movements do not cause damage
or injuries.
•
•
an adequate number of people.
• Lower the cutting means assembly.
• Position it so that it cannot cause a hazard for anybody.
•
to prevent it from tipping over.
11. MAINTENANCE TABLE
Intervention Frequency Notes
MACHINE
Check all fasteners ; Safety checks/check controls; Check the rear/lateral discharge guards;
Check the grass catcher bag and lateral discharge chute; Check the cutting means.
Before use
General cleaning and inspection; Checking for any damage to the machine. If nec-
After each use
Replacing the cutting means -
Check the battery charge status Before each use
*
Recharge the battery After each use
Once a month
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Authorised Service Centre
To Next Page
Loading...
