EN - 10
12. PROBLEM IDENTIFICATION
12.1 FOR MACHINES WITH ELECTRONIC CONTROL
PROBLEM PROBABLE CAUSE SOLUTION
1. After pressing the starter
come ON.
Safety key is not inserted or is inserted
incorrectly.
Safety key in “OFF” position.
Battery is not inserted or is inserted
incorrectly.
Open the hatch and check that the battery is
Low battery. Check the battery status and recharge if nec-
Incorrect battery combination.
following the instructions supplied in the "Tech-
nical data" table.
2. After pressing the starter
not come ON and the
signal.
Internal motor anomaly. Remove the safety key and contact the Author-
or repairs.
3. The motor shuts down
whilst working.
Battery is not inserted correctly. Open the hatch and check that the battery is
Low battery. Check the battery status and recharge if nec-
4. The danger LED lights up
(Fig. 30.A) and the ma-
chine emits an acoustic
signal.
Cutting means blocked.
and wear work gloves.
Check and eventually remove any obstructions
-
vent rotation of the cutting means.
-
Machine fault Remove the safety key and contact the Author-
or repairs.
5. The danger LED lights up
(Fig.30.A).
The thermal protection has tripped due
to overheating of the machine.
Wait for at least 5 minutes and restart the
machine.
6. The cutting means is not in good state. Contact the Authorised Service Centre for
the sharpening or replacement of the cutting
means.
7. Excessive noise and/or
vibration is experienced
whilst working.
cutting means is damaged.
safety key.
Contact the Authorised Service Centre for
8. Battery power reserve
is low.
Severe working conditions requiring
greater current absorption.
-
quirements.
To Next Page
Loading...
