EN - 11
9. The battery charger is
not charging the battery.
Battery is not correctly inserted in the
battery charger.
Recharge the battery in places with suitable
temperatures (see battery/battery charger in-
struction manual).
Dirty contacts. Clean the contacts.
The battery charger is not energised. Check it is plugged in and the power socket is
energised.
Faulty battery charger. Replace with an original spare part.
battery charger manual.
12.2 FOR MACHINES WITHOUT ELECTRONIC
CONTROL
PROBLEM PROBABLE CAUSE SOLUTION
1. The engine does not start
when using the switch
Safety key is not inserted or is inserted
incorrectly.
Safety key in “OFF” position.
Battery is not inserted or is inserted
incorrectly.
Open the hatch and check that the battery is
Low battery. Check the battery status and recharge if nec-
Incorrect battery combination.
following the instructions supplied in the "Tech-
nical data" table.
2. The engine stops and the
machine emits an acous-
tic signal.
Battery is not inserted correctly. Open the hatch and check that the battery is
Low battery. Check the battery status and recharge if nec-
The thermal protection has tripped due
to overheating of the motor.
Wait for at least 5 minutes and restart the
machine.
Cutting means blocked.
and wear work gloves.
Check and eventually remove any obstructions
-
vent rotation of the cutting means.
-
Machine fault Remove the safety key and contact the Author-
or repairs.
3. The cutting means is not in good state. Contact the Authorised Service Centre for
the sharpening or replacement of the cutting
means.
4. Excessive noise and/or
vibration is experienced
whilst working.
cutting means is damaged.
safety key.
Contact the Authorised Service Centre for
To Next Page
Loading...
