14
SAFETY CHECKS
Always carry out the safety checks before use.
Safety check before every use
–
–
– Keep all surfaces of the machine clean and dry.
Machine operating check list
Action Result
1. Start the machine (par. Start-Up).
2.
cutting blade.
1. The cutting blade should move.
2. The levers should return automatically and rapidly to the neutral
within a few seconds.
1. Start the machine (par. Start-Up).
2. Operate the drive lever.
3. Disengage the drive lever.
1. The cutting blade should move.
2. The wheels should move the machine forward.
3. The wheels should stop and the machine stops moving forward.
Test driving No abnormal vibrations. No abnormal sound.
If any of the results fail to match the action in
the table, do not use the machine! Contact a
Mounteld Authorised Service Dealer to have it
checked and repaired if necessary.
Start-up
NOTE Start the machine on a at surface without obstacles or
high grass.
Models with manual start handgrip
NOTE The engine brake lever / cutting blade must be kept
pulled to prevent the engine stopping.
NOTE The engine brake / cutting means lever must be kept
pulled to prevent the engine stop.
Operation
IMPORTANT When working, always keep a safe distance
from the cutting blade, given by the length of the handle.
Grass cutting
1. Start moving forward and mowing the grass area.
2. Adjust the speed and cutting height (par. Cutting
height adjustment) in relation to lawn conditions
(grass height, density and humidity) and the
amount of grass to be cut.
3. It is recommended to always cut at the same
height and in the two directions (Figure 15).
For mulching or rear grass discharge:
– Never cut more than one third of the total grass
height per single pass (Figure 14).
– Keep the chassis clean (par. Cleaning the cutting
blade assembly).
A
B
Figure 13
Figure 14
2
To Next Page
Loading...
Need help?
General
