Mova M1 - How to Use; Scheduled Cleaning; Mopping Function Usage

16 17
ENEN
OFF ON
R
R
L
L
Clean the Main Brush Clean the Sensors
Clean the Main Wheel/Omnidirectional Wheel
Clean the Side Brush
Routine Maintenance
1.Press the brush guard clips inwards to remove the brush guard and lift the
brush out of the robot.
Note: Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel.
Pull out the side brush and use the included cleaning tool to remove any hair
tangled in the brush.
2.Use a proper cleaning tool to remove any hairs tangled in the brush.
Note: Do not pull out the hair tangled in the main brush excessively. Otherwise,
the brush may be damaged.
Routine Maintenance
Note: Wet cloths can damage sensitive elements within the robot and charging dock. Please use dry rags for cleaning.
Wipe sensors and charging contacts by using a soft and dry cloth, as shown in the diagram.
OFF ON
R
R
L
L
Robot Restarting
Battery
If the robot stops responding or cannot be turned o, press and hold down
the button for 10 seconds or press the ON/OFF rocker switch to forcefully
turn it o. Then press and hold the button for 3 seconds to turn the robot
on.
The robot contains a high-performance lithium-ion battery pack. Please
ensure that it remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of
time, turn it o and put it away. To prevent damage from over-discharging,
the robot should be recharged at least once every three months.
OFF ON
R
R
L
L
Charging Contact
Cli Sensor
Charging Contact
Cli SensorCli Sensor
Charging Contacts
Edge Sensor
Return-to-Dock Sensor
Infrared Deceleration Sensor
Point Laser Sensor
Collision Detection Sensor and Bumper