What to do if my Movincool OFFICE PRO 18 does not operate?
If your Movincool Air Conditioner isn't turning on, check if the ground fault breaker has tripped and reset it if needed. Also, check if the drain tank is full (the FULL TANK LED will be flashing) and empty it.
Why is my Movincool OFFICE PRO 18 not cooling properly?
If your Movincool Air Conditioner isn't cooling effectively, start by checking the air filters to ensure they are clean. Next, verify that neither the air inlet nor the outlet is obstructed. Lastly, make sure the temperature is set to your desired level.
Why is my Movincool OFFICE PRO 18 not cooling enough?
If your Movincool Air Conditioner isn't cooling adequately, a possible cause is clogged plate fins. Ensure the set point temperature is lower than the room temperature.
What to do if the compressor is not operating on my Movincool OFFICE PRO 18 Air Conditioner?
If your Movincool Air Conditioner's compressor isn't working, it could be due to several reasons. First, make sure the unit isn't in Fan Only Mode and that Cool Mode is activated. Also, check that the set point temperature does not exceed the room temperature. Check the Jumper on Control Board (J104) and Jumper on Relay Board (J8 or J10). Other potential causes include a defective Condensate Pump (if equipped), a defective Compressor Capacitor, overload relay, Thermistor, Compressor Motor. Finally, check wiring connections, Relay Board and Control Board.
Why is my Movincool OFFICE PRO 18 making noise and shaking?
If your Movincool Air Conditioner is making abnormal noises or shaking, this could be due to a loose compressor mounting nut or a deformed/worn rubber grommet on the compressor mounting bolt. Also, check for internal interference with other components or a damaged/out-of-balance fan and scroll.
What to do if my Movincool Air Conditioner is leaking water?
If you notice water leaking from your Movincool Air Conditioner, ensure the drain tank is properly installed and not cracked. Also, check for any obstructions in the drain pan hole.
Why is the fan motor not working on my Movincool OFFICE PRO 18 Air Conditioner?
If the fan motor in your Movincool Air Conditioner isn't running, ensure that the fan mode switch isn't set to “Stop” when the current Set Point Temperature exceeds Room Temperature. If the unit is equipped with an optional Condensate Pump, verify that it is working correctly. Also, check the Jumper on Control Board (J104) or Relay Board (J8 or J10) and wire connections. A defective fan motor capacitor, fan motor, Relay Board or Control Board may also be the cause.
Why Movincool OFFICE PRO 18 does not turn on?
If your Movincool Air Conditioner unit is not operating at all, check for power at the receptacle, terminal board, and relay board. Inspect all wire connections and check the drain tank switch. Also, check the relay board fuse. Other potential issues include a defective relay board or a defective control board.
How to troubleshoot insufficient cooling in Movincool Air Conditioner?
If your Movincool Air Conditioner isn't cooling adequately, it might be because the environmental conditions exceed the design specifications. Check the air filter for clogs.
General| Brand | Movincool |
|---|---|
| Model | OFFICE PRO 18 |
| Category | Air Conditioner |
| Language | English |
To Next Page
