Rev 19 38 (EN)
move.
blue flashing
by a microcomputer.
Possible serious
damage to it.
Try to reboot the robot; a continuing
error indicates a serious damage to
the mother board.
cannot be
charged.
blue steadily
charging pins.
The battery has
reached its natural end
of life.
Please check it if the power source is
with problem, or clean the charging
pins if needed.
Replace the battery.
mower does
not boot.
red steadily
between the magnets
and the deck.
Take off the metal parts if needed.
Take appliance to a service dealer.
1. Make sure the main power switch is
“ON”.
2. When you first use the robotic
mower the battery may not be fully
charged. Put the robotic mower into
its charging station.
3. Hit the power key on control panel,
then input PIN and start the robotic
mower.
4. If the screen is still off, please carry
the robotic mower to the charge
station. Make sure the main switch is
“ON”
for the battery to be charged.
5. Contact the service station.
mower cannot
enter the
charging
station.
is not installed
correctly, the robotic
mower cannot enter it.
1. Make sure the LED indicator on the
charging station is constant green.
2. Check if the boundary wire under
and in front of the charger are
aligned.
3. Check if the charging station is
positioned correctly.
4. Level off the charging station.
mower circles
around along
the boundary
wire.
to or underneath the
boundary wire affects
the boundary signal.
Check if there is a high-power cable
close to the boundary wire or
underneath it; change the position of
the boundary wire.
mower
stopped while
running back
boundary wire blocked
the mower’s
movement.
Remove any obstacle on the
boundary.
mower
behaves
abnormally
around islands
(flower beds,
pool, etc.).
incorrectly placed
around the islands
Relocate the boundary wire.
To Next Page
Loading...
Need help?
General
