Rev 19 20 (EN)
2. Plug charger directly into an electrical outlet. Do not abuse the cord. Never carry
anything by or pull on the power cord.
3. Do not operate a damaged charger. Replace damaged cords or charger immediately at
an authorized service centre
4. Do not charge in wet locations. Do not charge at temperatures is above 40° C or below
5° C.
5. Keep the mower and charger away
from water, heat emitters or
chemicals. Be careful not to damage
the charger cord - by keeping it
away from sharp edges.
6. Connect the charger to the charging
station. Align the notch on the
power cord connector with the
groove on the adaptor connector.
Once these connections are made,
plug in the power supply. There
is a LED indicator on the charging
station – after proper installation, it
should flash in constant green. If
the LED is off, check the power
connections firstly; If the LED is on
but not constant green, refer to
the trouble shooting guide below.
green light
on
ready for mowing (battery
fully charged, boundary
wire OK)
green
connected wrongly
Change the two wire ends and check if
the boundary wire has a break
somewhere.
Await full charge or set “Start” – “OK”.
5
5
.
.
5
5
T
T
U
U
R
R
N
N
O
O
N
N
A
A
N
N
D
D
T
T
E
E
S
S
T
T
T
T
H
H
E
E
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
Once the LED light is constant green, you have a working area for your robot. Now please
first check that the boundary wire pegs are fully hammered down.
Cut boundary wire and its consequential damage not subject to
LED indicator
To Next Page
Loading...
Need help?
General
