Mowox RM 800 Li BT User Manual (English)

Other manuals for Mowox RM 800 Li BT

Questions and Answers:

N
Nicholas BarrettAug 20, 2025
What to do if my Mowox Lawn Mower stopped in the working area?
- C
  Cassidy BullockAug 20, 2025
  If your Mowox Lawn Mower stops in the working area, several factors could be the cause. It might be trapped by an obstacle or jammed between trees or bushes. Remove any obstacles or adjust the boundary wire layout to avoid the area. Also, check if the grass is too tall, blocking the mower's movement; if so, cut the grass to less than 60 mm. Restart the mower or return it to the charging station. If the issue persists, ensure the boundary wire is correctly laid, especially in narrow corners or around fences.
V
Vincent JonesAug 22, 2025
What should I do if my Mowox Lawn Mower turns in circles and then stops?
- M
  Michael ChavezAug 22, 2025
  If your Mowox Lawn Mower is turning in circles before stopping, it might be due to a boundary signal error. Ensure the mower is within the designated working area and that the LED indicator on the charging station shows a constant green light. If the mower repeatedly runs outside the boundary in a specific spot, check for nearby high-voltage cables and adjust the boundary wire's position. Similarly, if it occurs on a slope, alter the boundary wire to avoid that area. You can also try restarting the mower or taking it back to the charging station.
E
Elizabeth WeberAug 25, 2025
What to do if my Mowox RM 800 Li BT Lawn Mower stopped in tall and rough grass?
- T
  Tanya GonzalesAug 25, 2025
  If your Mowox Lawn Mower stops in tall and rough grass, this could be due to motor over-current or motor fault. First, ensure the grass is cut to less than 60 mm using a conventional mower. You can also increase the cutting height of the robotic mower. Check if the blade disk or wheels are jammed and clean them if necessary. Restart the robotic mower or take it back to the charging station.
J
jared61Aug 26, 2025
What to do if my Mowox Lawn Mower goes back to the station and stays there during scheduled working time?
- E
  Elizabeth HardingAug 26, 2025
  If your Mowox Lawn Mower returns to the station and remains there during its scheduled working time, it could be due to the PCB overheating. During the summer, schedule the working time for the early morning to avoid the hot daytime temperatures. Once the PCB cools down, the robotic mower will automatically resume its programmed schedule.
E
emily87Aug 27, 2025
Why my Mowox RM 800 Li BT doesn't move?
- B
  Brian GuerraAug 27, 2025
  If your Mowox Lawn Mower isn't moving, it might be due to a mainboard error. Try rebooting the robot. If the error continues, it indicates a serious damage to the mother board.
K
Kevin AdamsAug 29, 2025
What to do if my Mowox RM 800 Li BT tumbled and stopped?
- M
  Mark SmithAug 29, 2025
  If your Mowox Lawn Mower tumbled and stopped, it may be due to rolling over or tilting. If this is caused by steep slopes, adjust the boundary wire layout to avoid those areas. You can also take the mower to a flat surface and restart it.
J
John NguyenAug 31, 2025
What to do if my Mowox Lawn Mower stopped while running back to the station?
- J
  Jeffrey CohenAug 31, 2025
  If your Mowox Lawn Mower stopped while running back to the station, remove any obstacle on the boundary.
P
Patricia JohnsonSep 2, 2025
Why is my Mowox Lawn Mower very noisy?
- G
  gonzalezkimberlySep 2, 2025
  If your Mowox Lawn Mower is making excessive noise, replace all three blades simultaneously, as the mower's cutting efficiency depends on sharp blades. Stop the robotic mower and use gloves to remove any debris from the blades to avoid injuries. If the problem persists, the motor may need repair or replacement by a service station.
V
Victoria BlankenshipSep 3, 2025
What to do if my Mowox Lawn Mower screen is off?
- K
  Katherine PayneSep 3, 2025
  If the screen on your Mowox Lawn Mower is off, try pressing the power key on the keyboard for 3 seconds to turn the LCD screen on. Also, ensure the main power switch is set to “ON”. If you are using the mower for the first time, the battery may not be fully charged, so place it in the charging station. You can also try hitting the power key on the control panel, then input your PIN to start the mower. If the screen remains off, place the mower in the charging station, ensuring the main switch is “ON” to allow charging.
G
Gary JohnsonSep 5, 2025
What to do if my Mowox RM 800 Li BT Lawn Mower robotic mower stopped in the working area because it was lifted?

Mowox RM 800 Li BT Specifications

General

Type	Robotic Lawn Mower
Battery Type	Lithium-ion
Voltage	20 V
Cutting Width	18 cm
Cutting Height	20-60 mm
Max Area	800 m²
Bluetooth	Yes
Grass Catcher Volume	N/A (Mulching)
Warranty	2 years
Motor	Brushless
Blade Type	3 blades