Mowox RM 800 Li BT User Manual

Rev 7 20 (EN)
an authorized service centre
4. Do not charge in wet locations. Do not charge at temperatures is above 40° C or below
5° C.
5. Keep the mower and charger away
from water, heat emitters or
chemicals. Be careful not to damage
the charger cord - by keeping it
away from sharp edges.
6. Connect the charger to the charging
station. Align the notch on the
power cord connector with the
groove on the adaptor connector.
Once these connections are made,
plug in the power supply. There
is a LED indicator on the charging
station – after proper installation, it
should flash in constant green. If
the LED is off, check the power
connections firstly; If the LED is on
but not constant green, refer to
the trouble shooting guide below.
LED
description
solution
off
no power
Check power supply.
constant
green light
on
ready for mowing (battery
fully charged, boundary
wire OK)
Correct connection.
flashing
green
boundary cut off or
connected wrongly
Change the two wire ends and check if
the boundary wire has a break
somewhere.
red
battery on charging
Await full charge or set “Start” – “OK”.
5.5 TURN ON AND TEST THE INSTALLATION
Once the LED light is constant green, you have a working area for your robot. Now please
first check that the boundary wire pegs are fully hammered down.
Cut boundary wire and its consequential damage not subject to
warranty.
LED indicator

Mowox RM 800 Li BT Specifications

General

Brand	Mowox
Model	RM 800 Li BT
Category	Lawn Mower
Language	English