Rev 19 21 (EN)
warranty.
Now place your robot into the working area, next to the charging station.
A green flashing LED on the base station indicates wrong
installation of the boundary wire.
Press the main power switch to “ON”.
Now press the power soft button
.
After a short boot of the operating system,
enter the PIN code “1234” as follows:
.
Confirm with , press and then
again
.
Now your mower should follow the
wire in an anti-clockwise direction and
dock into the charging position. The
mower will start to fully charge. If
robot misses
to
dock, you might have
to adjust the charging station sideways
until the robot docks without any
pr
oblem.
To Next Page
Loading...
Need help?
General
