Rev 19 39 (EN)
mower is
very noisy.
blades.
2. Cutting blade
flooded by residues
(tapes, ropes, plastic
fragments, etc).
3. Damaged cutting
motor or driving motor.
4. Other damages on
the parts of the mower.
1. Replace blades; the 3 blades need to
be changed at the same time.
The robotic mower’s cutting
efficiency depends on sharp blades,
so please keep them in good
condition.
2. Stop the robot. Use gloves to avoid
any risk of injuries and remove any
residues from the blades.
3. Get the motor repaired or replaced
by the service station.
mower stays
on the
station or the
mower keeps
going back to
the station.
setting.
Check the working time setting.
Outside of the set working time
window, the robotic mower will hover
to the station and stay there.
operates
during rain.
the resistance of the
surface, which can
change due to dirt.
Clean the rain sensor with a cloth
soaked in a detergent solution.
If in doubt, bring your robot in for service.
Strictly follow the instructions of this manual. Faulty maintenance
or installation are not covered by the warranty
To Next Page
Loading...
Need help?
General
