Rev 19 29 (EN)
and wheels, leading you to more frequent cleaning of the unit.
•
Do not use the robotic mower during lightning to avoid
damage to the electronic circuits. We strongly recommend to
unplug the charging station and to disconnect the boundary
wire from the base station, too.
6
6
.
.
6
6
C
C
H
H
A
A
N
N
G
G
E
E
P
P
I
I
N
N
C
C
O
O
D
D
E
E
Change the PIN code when the main power switch is set “ON”
Every time you open the LCD cover, you need to input the PIN code to unlock the robotic
mower.
The factory-set PIN code is “1234”; you can change this PIN code as below:
1. Enter the valid keyword “1234”.
2. Simultaneously push the lock button and the OK button. The lock indicator and the
operation LED flash red and green alternatingly.
3. Enter a new PIN, e.g. "1-1-1-1" and press OK. The lock indicator and the power indicator
flash green. Two beeps of the robot indicate: The PIN has been changed successfully.
Please write down your new PIN here:
_ _ _ _
Every time you change the PIN, please write it down to remember. Without the correct PIN,
your robot is anti-theft protected and all functions are blocked.