Need help?Do you have a question about the Moxa Technologies NPort 5110 Series and is the answer not in the manual?
General| Model | NPort 5110 Series |
|---|---|
| Category | Serial Device Server |
| Serial Ports | 1 |
| Interface | RS-232/422/485 |
| Ethernet Ports | 1 |
| Data Rate | 10/100 Mbps |
| Baud Rate | 50 bps to 921.6 kbps |
| Data Bits | 5, 6, 7, 8 |
| Stop Bits | 1, 1.5, 2 |
| Parity | None, Even, Odd, Space, Mark |
| Power Input | 12 to 48 VDC |
| Flow Control | XON/XOFF |
| Protocols | TCP, UDP, ICMP, ARP, DHCP, HTTP, Telnet |
| Humidity | 5 to 95% RH |
| Certifications | CE, FCC, UL |
Step-by-step instructions for the physical installation and connection of the NPort 5110.
Guide on how to properly connect the power supply to the NPort 5110 device.
Instructions for establishing an Ethernet network connection for the NPort 5110.
Guidance on connecting serial devices to the NPort 5110's RS-232 interface.
Determining whether to use a Static or Dynamic IP address for the NPort 5110.
Explanation of the TCP Server mode for connecting serial devices over TCP/IP.
Explanation of the TCP Client mode for establishing active TCP connections.
Describes the Real COM mode for preserving existing serial communication software.
Configuration of IP address, Netmask, Gateway, and DNS server details.
Configuration of serial communication parameters like baud rate, data bits, and parity.
Detailed configuration parameters for the Real COM operation mode.
Detailed configuration parameters for the TCP Server operation mode.
Detailed configuration parameters for the TCP Client operation mode.
Configuration to control device access based on specific IP addresses or subnets.
Step-by-step guide for installing the NPort Administration Suite on a Windows PC.
Procedure to unlock a password-protected NPort 5110 using the Administrator software.
General steps for configuring NPort 5110 device settings using the Administrator tool.
Instructions for updating the firmware on NPort 5110 devices.
Process for mapping NPort serial ports to host COM ports for application access.
To Next Page