NPort 5110 Series User’s Manual Web Console Configuration
5-29
Change Password
Input the “Old password” and “New password” to change the password. Leave the password boxes
blank to erase the password. If the password is erased, then NPort 5110 will not have password
protection.
ATTENTION
If you forget the password, the ONLY way to configure NPort 5110 is by using the Reset button
on NPort 5110’s casing to “Load Factory Default.”Remember to export the configuration file
using Windows Administrator when you finish the configuration. By using the Import function
of Windows Administrator, your configuration can be re-loaded into NPort 5110 after using
“Load Factory Default.” Refer to Chapter 6 for more details about the Export and Import
function.
Load Factory Defaults
This function will reset all of NPort 5110’s settings to the factory default values. Be aware that
previous settings will be lost.
To Next Page
Loading...
