MR MESSKO MT-ST Compact RM - Page 49

5 Installation and commissioning
49BA5831400-00 EN
4. Route a sufficient length of connection cable through the cable gland and
adapter and tighten the cable gland.
Figure30: Cable gland
5.4.4.3 Offshore cable gland (stainless steel)
1. NOTICE! If the cable gland is not used, equip it with a sealing plug or re-
place the entire cable gland with a dummy plug in order to ensure the IP
degree of protection.
2. Remove the locking screw on the adapter.
Figure31: Removing the locking screw