Need help?Do you have a question about the MR TAPMOTION ED Series and is the answer not in the manual?
General| Type | On-Load Tap-Changer |
|---|---|
| Series | ED |
| Application | Power Transformers |
| Drive Type | Motor Drive |
| Operating Principle | Resistor Transition |
| Oil Type | Mineral Oil |
| Standards | IEC 60214 |
| Material | Copper, Insulating Materials |
| Weight | Depends on Model |
| Power | Dependent on motor-drive unit |
| Speed | Dependent on motor-drive unit |
Information about the product manufacturer, Maschinenfabrik Reinhausen GmbH.
Specifies supporting documents and regulatory compliance for the technical file.
Explains the system for displaying warnings using signal words and pictograms.
Details how information and instructions are presented for clarity and understanding.
Defines typographic conventions used throughout the technical file for consistency.
Defines the intended use of the motor-drive unit and conditions for safe operation.
Provides essential safety instructions covering PPE, work area, and operational conditions.
Defines qualifications for personnel involved in installation, operation, and maintenance.
Details required personal protective equipment (PPE) for safe work.
Lists included components and explains the unit's operational function.
Details the product designation and variants for TAPMOTION® ED.
Provides an overview of the motor-drive unit's design and components.
Describes the indication field and the function of the anti-condensation heater.
Describes the swing frame and terminal rail for protection and connections.
Explains the use and connection of position transmitter equipment.
Warns about electrical voltage danger if the cover plate is not fitted.
Lists the protective devices integrated within the motor-drive unit.
Overviews the safety markings used on the product and their meanings.
Details packaging methods, stacking guidelines, and suitability for transport.
Explains the shipping pictograms for safe transport and correct storage.
Provides safety warnings and procedures for shipping and handling.
Provides guidelines for proper storage of packaged goods after receipt.
Instructs on unpacking procedures and checking shipments for damage.
Step-by-step instructions for mounting the motor-drive unit onto the transformer.
Refers to separate instructions for mounting drive shafts and bevel gear.
Provides instructions and safety warnings for centering the unit.
Recommendations for using shielded signal lines to prevent interference.
Instructions for installing the electrical components of the motor-drive unit.
Step-by-step guide for the initial startup and commissioning of the motor-drive unit.
Outlines tests to verify the correct functioning and safety of the motor-drive unit.
Procedure for testing the correct electrical switch-off functionality.
Method for checking mechanical and electric end stops of the unit.
Procedure for testing the motor protective switch's tripping function.
Details high-voltage and dielectric tests to be performed on the transformer.
Steps for safely transporting the transformer, including drive unit handling.
Procedures for commissioning the transformer at the final operating location.
Instructions for operating the unit remotely using control pulses.
Procedures for operating the unit locally via control switch or hand crank.
Detailed instructions and safety warnings for operating the unit with the hand crank.
Critical safety instructions for fault finding and rectification procedures.
General advice on documenting and reporting faults for troubleshooting.
Identifies common faults occurring outside the unit and their remedies.
Describes faults where the switching operation is incomplete.
Addresses faults occurring after a completed switching operation.
Discusses the use of the hand crank in emergency fault situations.
Instructions for cleaning and caring for the motor-drive unit.
Details periodic inspections for the motor-drive unit.
Information on maintenance requirements and component replacement intervals.
Critical safety warning regarding energized components during disassembly.
Provides detailed technical specifications for the TAPMOTION® ED unit.
Specifies technical data for the position transmitter equipment.
Lists permissible operating and storage temperatures for different unit versions.
To Next Page
