MRC Ltd
10 http://www.mrclab.com/
Picture 7
1.5.7. Connect base cabinet with main body
a) Lift the main body and place it on the base cabinet. Make sure each side is in
alignment. Besides, please also make sure the mounting holes of bolt (as shown
in Picture 9) at the bottom of the main body are in alignment with the holes on
the top plate of the base cabinet
b) Make sure the main body and base cabinet are stable enough to prevent side-slip.
Open the doors of the base cabinet and take out the components from the
accessory bag
Stainless steel hexagon socket head cap screw M10×20
Stainless steel hexagon nut M10
Stainless steel flat washer 10 and spring washer 10
Insert the hexagon socket head cap screws (M10×20) into the holes at the bottom
of the main body (refer to the Picture 8). These screws should pass through the
main body and the base cabinet. Use flat washer 10, spring washer 10 and nut
Pull out this work
table to reveal the
bolt holes
To Next Page
Loading...