MRC PH-230SD - Page 27

8-7 Select the Temp. unit to or ℃℉
When the lower display show " t-CF "
1)Use the " Button " ( 3-5, Fig. 1 ) or " Button "▲▼
( 3-6, Fig. 1 ) to select the upper Display text to " C " or
" F ".
C - Temperature unit is ℃
F - Temperature unit is ℉
2)
After Display unit is selected to " C " or " F ", press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
function with default.
8-8 Set pH manual Temp. compensation value
When the lower display show " t-SEt "
1)This function only for the pH measurement of
adjusting the pH electrode's manual Temp.compensation
value. The default value is 25 ( 77 ).℃℉
2)Use the " Button " ( 3-5, Fig. 1 ) or "
Button "▲▼
( 3-6, Fig. 1 ) to select the upper value to the desired
Temp. compensation value (
or ), then press the ℃℉
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
value with default.
8-9 ESC
When the display show " ESC "
When the Display show the text " ESC ", then press the
" ESC Button " ( 3-3, Fig. 1 ) will finish the Advanced
Setting procedures and return to the normal measuring
screen.
25